Testing your device
Tetsu OS is developed on one RG35XX SP, which has LPDDR3 memory. Builds after v0.1 also start on units with LPDDR4 memory, but no LPDDR4 unit has run one yet. If you have one, a test tells us whether it works. It takes about fifteen minutes, and a card that doesn't start does no harm.
Before you start
- Find out your memory type from the stock card, as shown in Check your memory type. It helps to know what to expect, but you can test without it.
- A spare microSD card of at least 6 GB. Writing the image erases it. Don't use the stock firmware card.
- The test image: the newest pre-release marked TEST on the Releases page. Write it as shown in Installation.
Nothing on the device changes
Tetsu OS runs from the card. The internal storage is not touched: take the card out, and the stock firmware starts as before.
1. Start the device
Put the card in TF1, unplug the USB cable and press the power button. Watch the screen and the green light for a minute:
| What you see | What it means |
|---|---|
| The logo, then the setup | It works. Go on to step 2. |
| No picture, and the green light blinks about once a second | The memory setup failed: neither memory type worked. |
| The green light stays on, but the screen stays dark or garbled | The memory works, but something later doesn't, often the screen. Builds from v0.2-test.2 on detect which of the SP's two screens yours has, and this is how a wrong guess would look. |
| Nothing at all | Check the card is in TF1 and the battery is charged, and try again. |
If it doesn't start, take the card out and put it in your computer. A drive named TETSU-BOOT appears. If it has a file named bootlog.txt, Linux started, and the file says how far it got: attach it to your report. No bootlog.txt means Linux didn't start.
2. Check the memory
Go through the setup, then open Settings > SYSTEM > SYSTEM INFO. The MEMORY row shows the memory the device found, like 1 GB LPDDR4 - 850 MB FREE. If it says LPDDR3 on a unit whose stock card says LPDDR4, or the other way round, please say so.
3. Try it for a few minutes
Each of these takes a minute or two. Note anything that doesn't work as you'd expect:
- A game: add one as shown in Adding games, play it for five minutes, and listen to the sound, through headphones too.
- Sleep: close the lid for about a minute, open it, and carry on playing.
- Wi-Fi: connect to your network in Settings > WI-FI.
- Power: turn it off with the power button, wait ten seconds, and turn it on again.
4. Send the report
On SYSTEM INFO, press X. It saves the logs to the card's TETSU-BOOT drive, in logs. They hold no passwords or keys. Then open a hardware test report and attach logs/system.txt, logs/launcher.log and bootlog.txt.
A report that it works is as useful as one that it doesn't. Thank you!
